Follow

Removing and Reapplying Mount

To remove your mount, start on the its edge and carefully pull the mount off the vehicle's dashboard. The suction base on the medium and tall mounts includes a tab which you can use while removing Navdy from your dashboard.

When reapplying your mount perform the following steps to ensure a strong fit:

Short Mount

  1. Do not clean the underside of the short mount before reapplying it to your dashboard. If you find the short mount's adhesive isn't sticky, please reach out to Navdy Support.
  2. Clean your dashboard with water and a small amount of soap.
  3. When the dashboard is dry, firmly press the mount down onto your car's dashboard. Feel free to reference the Short Mount Installation video in order to see how do this.

Medium & Tall Mounts

  1. Clean the adhesive on the bottom of the medium or tall mount by running water over it and gently wiping away dirt. Allow time for the mount to fully dry. 
  2. Clean your dashboard with water and a small amount of soap.
  3. When your dashboard is dry, firmly press the mount down onto your car's dashboard. Reference the Medium and Tall Mount Installation video in order to see how do this.
Was this article helpful?
0 out of 1 found this helpful
Can't find what you're looking for?

Submit your question here

Or ask our Community!